Flight Technology

Session 1

In session 1, we learned about the basic aerodynamics. We also experimented with the software that simulates air flow.

Session 2

In session 2, we examined the factors that change lift. We also began the construction of our wing.

Session 3

In session 3, We completed the construction of our wing. We used chipboard, construction paper, glue, scissors and tape.

Session 4

In session 4, we tested the amount of lift produced by wind  flowing over our wing. We also explored the basic controls on a Cessna.

Session 5

In session 5, we flew a Cessna using Flight simulation software.

Session 6

In session 6, We performed some basic flight maneuvers using the Flight Simulator software. We also used a navigation plotter to determine the direction and distance of a flight being planned.

Session 7

In session 7, we used the Fight Simulator software to test the accuracy of one of our calculations.

Comment Stream