Your E-Cigarette Clearomizer Stopped Working?Try These Solutions

Some people tend to experience issues with their e-cigarette clearomizer once in a while. And these issues may include a horrible burnt taste, leaking, no vapor production, and even a complete stop working. Although issues with your device can be frustrating, sometimes it can be something simple to resolve such as refilling your device or recharging your battery. If your e-cigarette clearomizer has stopped working, try the following solutions.

Check the Battery

First and foremost you should make sure that the battery is turned on and also charged.

Connection Issue

If you find out that the battery or heating element is not working, the center plate in the threaded connection may be the problem. If it is not in place, it can cause the device not to complete the circuit. This is usually caused by over-tightening the device.

It is recommended to try adjusting the heating elements plates first before you move to the battery's plate. Follow below.

Adjusting the Device Heating Element

  • Make sure the ohms of your heating element is not broken. Use a multimeter for this.
  • Remove the heating element from the battery.
  • Clean and dry threads of the heating element.
  • With caution, place a small flat blade screwdriver in the gap between the threads and the plate. You just need to insert the tool a little.
  • Pull the center plate up just a little. Slowly move around the connection and do it a few more times. Remember, you just want to lift the plate a little be. If you raise it too high you can damage the heating element.
  • Check if the plate is on the center of the connection.
  • Screw the heating element back on to the battery and see if it works.

Your e-cigarette clearomizer should be ready to be vaped again. If not try the next step.

Adjusting the Device Batteries Plate

  • Remove the heating element from the battery.
  • Clean and dry the threads of the battery.
  • When using an automatic battery, do not place anything down in the small gap between the threads and the center plate It can cause damage on the wires and circuit of the battery.
  • With caution place the screwdriver in the gap between the threads and the plate. Slip the hook under the plate a little.
  • Pull the center plate up just a little. Move around the connection carefully and do it a few more times. Remember, you just want to lift the plate a little be. If you raise it too high you can damage the battery.
  • Check if the plate is on the center of the connection.
  • Place the battery back in the device and turn it on.
  • Re-attach the heating element and check if it is working.

Things to Remember

  • Never attempt adjusting the heating element or battery plate with the battery in the ON position.
  • Never try this with a battery model that can not be turned off.
  • Never pull the plate all the way out.